The DICKOW®-Inline-Pumps, series NCV / NCVL, have been developed for the chemical, petrochemical and related industries.

Since the pumps are installed inline, only a minimum of space is required and therefore, these pumps are suitable for package units. No time-consuming alignment of couplings is required. Ball bearing failures through inadequate alignment are excluded.

With a wide selection of materials and shaft sealing systems, the NCV-pumps are suitable for handling nearly all kinds of liquids used in the above mentioned industries.
For example: acids, lyes, hydrocarbons, hot water up to 234 ºC (455 ºF), hot oil up to 350 ºC (660 ºF), cooling fluids, solvents etc.
Unit of Measure

Type

N/A NCV

Industry Standards

N/A ISO 9001

N/A Construction
The DICKOW®-Inline-pumps are single stage, single-flow volute casing pumps in vertical construction with inline flange arrangement. The drive motor is connected with the pump casing by a motor support lantern.

Different designs are available.

  • Type NCV
    The pump shaft is connected with the motor shaft by a clamping device and secured by a key.
Drive motors
All standard flange mounted motors can be applied without any modification. No special shaft designs are required.

Pump shaft, bearings
The connections "shaft nut - impeller hub" and "impeller hub - shaft sleeve" are sealed by confined gaskets, preventing contact of pumped liquid with the pump shaft.

The NCV-type has the pump shaft rigidly clamped to the motor shaft and therefore, guided in the motor bearings.

Impeller
To minimize thrust load, the impeller is fitted with wear rings and balancing holes in the hub. The impeller is keyed to the pump shaft and secured by shaft nuts with Heli-Coil insert. Impellers are properly statically balanced according to DIN ISO 1940 T1 with a grade of G 6.3. This grants smooth vibration free running.

Intermediate casing
The intermediate casing separates the pumped liquid from the atmosphere by the sealing system and by confined casing gasket.